Making Your Own Golf Clubs
For the amateur golfer, making your own set of golf clubs or just that one special club can be a lot of fun, and it could help your game.
You may ask why you would ever want to build your own golf clubs.Well, the big reason is that when you buy clubs off the shelf, you are stuck with the sizes and fits that are in stock – limited only.There may be one size for men, another for the women and another for the children who need junior golf clubs. For someone with a 6′ 2″ height, buying off the rack can cause one’s golf game to suffer and cause annoying back aches because the clubs that was picked were too short. By learning to make your own golf clubs you can help your body and save some cash at the same time.
There really isn’t much needed to make one’s own golf clubs. You just need a head, shaft, grip and some materials to hold it all together. Searching the internet will give you many options to buy your components to make clubs that match your game.
Club heads — iron and wood heads are available from many suppliers. You can buy club heads that resemble popular brands or designs unique to the manufacturer you buy from. Each vendor offers their own line of clubs.
Shafts – you can buy the same shafts that most of these branded golf club companies use.
Grips – there are a variety of sizes and types of grips.You can find them in different prices and even get the same ones the pros use..
Ferules — That’s the little plastic piece that goes on the end of the shaft above the club head on some clubs. These are purely decorative except on graphite shafts where they are necessary to absorb some of the stresses where the shaft joins the club head.
The beauty of finding the components to make your own club is the fact that you can actually mix and match the components to match your game.
Some of the tools needed are:
Grip tape – two sided tape is needed
Grip tape solvent – very cheap and you can recycle the excess
Epoxy – you will needs an epoxy with a drying time of 2-3 hours
Pipe cutter for cutting steel shafts, a plumbing cutter will work fine
For graphite shaft use a hack saw
Grip cutting knife – one with a hooked blade works nicely
Sandpaper for roughing up shaft tips to epoxy them
Shaft clamp – a thick piece of rubber in a vise works well
Making a golf club consists of measuring and cutting the shaft to length, abrading the tip to make sure the bond to the head is as good as possible. You then push the ferrule over the thin end of the shaft and glue the head to the shaft with epoxy. Waiting for the epoxy to dry is the worst part of the job… take the newly made golf club to the course and try it out. Once the epoxy has set, you wrap the butt end of the shaft with grip tape (double-sided sticky tape), wet it using one of a wide range of solvents, slide the grip over it and let dry. Now you clean your new golf club, polish the ferrule and end up with something better then you can buy at a store.
So get to your computer, surf the net and find great websites to get your components. In no time you will your own homemade golf club or clubs. So, go and have some fun.
Those who play golf know it’s addictive. Building your own clubs can result in a similar addiction, so be warned.
Mail this post
Discussion Area - Leave a Comment